. OPERATION OPERATION STOP FUNCTION WHEN FOREIGN MATERIAL IS CAUGHT CAUTION 2. stop the optional equipment. (1) Vibratory sieve start switch (2) Secondary conveyor start switch (3) Muck discharge conveyor start switch 3 - 97 This machine is designed so that the lock cylinder slips and open s the clearance if any f oreign material is crusher. This de sign prevents breakage o f the crusher bearings, sh aft, or frame. However, this do es not mean that it is per mitted to load the crusher with such foreign mate The re is a limit to the number of times that the lock cylinder can slip .
If the crusher is used in a way that makes t he loc k cylinder slip frequently, it will become necessary to make early replacement of the cylinder and rep lacement of other structura (Suitable frequen cy of slipping: less than o aded i nside the If a ny foreign material (excessively l arge lumps of iron, et c.) has been loaded into the crusher or the re is an abnormal load on the crusher, the lo ck cylinder may slip a nd the crusher cleara nce may become larger. If this large happens, the c rusher and feeder stop and the horn sounds for 5 seconds. Sto p the engin e, remove the foreign m aterial caught in the c rusher, and check th at there is no abnormali ty at any par t.
In a ddition, the actual crusher clearan ce may be larger than the value displayed o n the monitor clearance display, so b ring the fixe d plate and jaw plate in to contact, then adjust the crusher clearanc e. For details, see "CHE CK AND ADJUSTMENT OF JAW CRUSHER ( PAGE 4-35)". After a djusting, start operat ions again. CHECK AND CONFIRMATION OF JAW CRUSHER AFTER WORK 1. After feeding of the material for crushing on the grizzly feeder stops, press work equipment stop switch (1) to stop the work equipment. The work equipment stops in the following order. Feeder -> crusher, conveyor, magnetic separator 1.
After feeding of the material for crushing on the grizzly f stops, press work equipment stop switch (1) to stop the equipment. The work equipment stops in the following o Feeder -> crusher, conveyor, magnetic separator After feedin g of the material for cr ushing on the grizzly f stops, pres s work equipment stop switch (1) to stop the With the w ork equipment stop switch, optional equip does not st op, so press the switc hes in the following or CHECK AFTER FINISHING WO RK For normal sto p of the engine, see th e section of "STOPPIN G ENGINE (PAGE