. OPERATION OPERATION 3 - 102 5. Do not try to look into the c rushing chamber while in operati on. That is ve ry dangerou s, because c rushed debr may fly off and hit you. top feeding debris first, next g to be crushed any more in the crusher chamber and then stop it. crusher chamber. 6. To stop the jaw crusher, s check that there is nothin g to be crushed any more in the crusher cha mber and the 7. Do not blast debris in the 8. If it becomes necessary t o hang a parts at the time of repl acing wear p arts, do not go under the hung parts. 9. Retighten each bolt suffic iently. ance at the outlet of the crusher, do so only after the crusher has been complete 10.
When adjusting the clear stopped. For details, see "CHECK AND ADJUSTMENT O F OUTLET CLEARANC E (PAGE 4-3 5)". 11. Do not feed a reinforcing bar exceeding 600 mm (23.6 in) in length an d 13 mm (0. 5 in) in diam eter, becaus it can cause a trouble to t he jaw crusher and the primary conveyor. are ace will 12. If the teeth of the swing ja w plate and the fixed jaw plate worn out beyond the specified limit, either reverse or repl the jaw plate. -> If used beyond the specified limit, the worn jaw plate cause a serious damage to the jaw crusher main body. worn out beyond the spe cified limit, either reverse or repl the jaw plate.
-> If used beyond the sp ecified limit, the worn jaw plate cause a serious damage 13. Procedure and caution fo r removing foreign objects inside crusher r than crushable materials (rock an Should foreign objects s uch as iron lumps and wooden blocks othe concrete block) have bee n fed, mixed with debris, and clogged the jaw crusher, remove them following th instructions given below. 14. Do not feed debris of the maximum of feed dimension into the crusher. The crushin g ability of th e crusher w be reduced and the produ ctivity will go down. In addition, an excessive crushing for ce will becom e necessar so this may result in dam age to the crusher itself.
so that the amount of debris in the crusher is a maximum of approx. 80% (averag 15. Adjust the grizzly feeder so that the amount of debris in t 0% (averag 60%). Never fill the crus her. This will cause abnormal wear of the t op of the ja w plate and itself. an excessiv crushing force will becom e necessary, so this may result i n damage to the crusher