. OPERATION TRANSPORTATION LIFTING MACHINE WARNING actually installed on the machine. For the proper lifting 3 - 128 The operator carrying out tha lifting operation using a cr ane must be a proper ly qualified cran e operator. Never raise the machi Always make sure tha t the wire rope is of ample strength for the weig ht of thi When lifting, keep the When carrying out lif unexpectedly. Never enter the area u Never try to lift the mach ine in any posture other than the po sture given in the pr ocedure below o r using liftin g equipment other than in the prosedure be There is a hazard that tha NOTICE The lifting procedure app lies to machines with standard spe cifications.
The method of lifting dif procedures, contact you For details of the weig ht, see "SPECIFICATIONS (P AGE 5-2)". s follows: e t ft k When lifting the mach ine, perform the operation on fl at ground a s follow 1. Set to the transportation posture when lifting the whol machine. 2. Set travel lever lock to the LOCK position. 3. Pass the lifting wire between the 1st and 2nd track rollers a both the front and rear. 4. Set the lifting angle (A) of the wire rope to 30° to 40°, then li the machine slowly. 5. After the machine comes off the ground, check the hoo condition and the lifting posture, and then lift slowly. portation posture when lifting the whol ck to the LOCK position.
re between the 1st and 2nd track rollers a 5. After the machin lifting posture, and then lift slow