. MAINTENANCE OUTLINE OF SERVICE 4 - 7 KEEPING AND STORING OIL, FUEL r impurities from getting in. Keep indoors to prevent any water, dirt, or othe When keeping drum cans for a long period, put the drum on its side so that the filler port of the drums is at the side to prevent moisture from being sucked in. If drums have to be stored outside, cover them with a waterproof sheet or take other measures to protec t them. To prevent any change in quality during long-te rm storage, be sure to use in the order of first in - first o ut (use the oldest oil or fuel first). FILTERS Filters are extremely important safety parts. T important equipment and causing problems.
Replace all filters periodically. For details, see t However, when working in severe conditions, r (sulfur content) being used. hey prevent impurities in the fuel and air circuits from entering he Operation and Maintenance Manual. Replace all filters periodically. For details, see t However, when working in severe conditions, r eplace the filters at shorter intervals according to the oil a nd fuel (sulfur content) being used. d use them again. Always replace with new filters. articles are attached to the old filter. If any metal particles are ore they are to be used. gly recommended.
Never try to clean the filters (cartridge type) an When replacing oil filters, check if any metal p found, contact your Komatsu distributor. Do not open packs of spare filters until just bef Use of Komatsu genuine filter elements is stron RELATING TO ELECTRIC SYSTEM If the wiring gets wet or the insulation is damage d, there may likely be short circuit. That is very dangerous , since a defective electric parts often results in an err atic motion of the machine. Hence avoid to splash water on the electric accessories and repair damaged insula tion. Inspection and maintenance works include che cking the fan belt for tension and damage as well as the battery for electrolyte level.
s installed on the machine or disassemble them. n those specified by Komatsu. Never try to dismantle the electrical accessorie Never install any electric components other tha When washing the machine, or when it rains, ta ke care so that the electric accessories do not get splash ed with water. External electro-magnetic interference may cau se malfunction of the control system controller, before in stalling a radio receiver or other wireless equipment, c ontact your Komatsu distributor. When the machine is operated on a seaside, ta ke a good care of the electric accessories so that they do not get corroded.
OUTLINE OF HYDRAULIC EQUIPMENT The hydraulic components are hot during and ri ght after operation. Moreover they are under high pressur e while in g out inspection or maintenance work for them under such Inspection and maintenance include checking t he hydraulic system for oil level, replacement of filter ele ments and replacement of hydraulic oil. When disconnecting the high pressure hoses, c heck that there is no flaw on the O rings. Replace it with ne w one, if any.
When the hydraulic oil filter elements or strainer s are cleaned or replaced, or when any hydraulic compon ent has been repaired or replaced, or when a hydraulic piping has been disconnected, bleeding air from the hy draulic system is required.