. MAINTENANCE SERVICE PROCEDURE WARNING Use city water for the coolant. 1. 2. Remove the undercover, then set the container under drain valve (2) to catch the coolant mixture. coolant. 3. idling to raise the temperature to at least 90 ° C (194 ° F), then continue to run for approx. 10 minutes. 4. 5. 6. Close drain valve (2). 7. Install the undercover. 8. 9. 10. of the sub tank LOW 11. and add water if the level is low.
4 - 30 ble, so be particularly careful to keep it aw When removing the drain plug, b e careful n wash your eyes immediately wit h ample wa ter, then consult a doctor for tre er or other such water supp ly must be used, contact your Komats se of a super coolant densit y meter to r of at least 44 liters (11.62 US gal) to (1) slowly and remove it.
(2) at the bottom of the radiat or and dra coolant, close drain valve (2), and fill wi adiator is full, start the engin e and run open drain valve (2), and dra in the wa water, clean the radiator wit h deterge method, follow the instruction of deterg h the water filler up to the fill e at a low speed for 5 minute s, then at es to bleed air mixed in the co oling wat e water filler cap removed.) the coolant of sub tank (3), c lean the i nd refill the water between F ULL and nd tighten the cap. Check th e coolant