Komatsu — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4. Set clearance adjustment selector switch (3) to position A (automatic). OSS the following order. 1) Use UP switch (4) or DOWN switch (5) to move the cursor on the screen display to position (A). or the in input the the is 4 - 38 5. Check that clearance ad justment monitor (D) of the mac tomatic) mode, then input the usted to the machine monitor in monitor is set to A (au clearance (A) to be adj 2) Press input confirma tion switch (6). (A) starts flashing numeral input windo screen. w (B) is displayed at the top left o 3) Use UP switch (4) decrease the value desired set value.

The numerical value in a range of 50 to 1 If the UP switch (4) continuously, the se units of 10 mm (0.4 i or DOWN switch (5) to increas on the display and adjust to give can be set in units of 1 mm (0.03 50 mm (2.0 to 5.9 in). or DOWN switch (5) is kept pre t value will increase or decreas n). esired OSS clearance, press i 6) to set the input value. 4) After inputting the d confirmation switch ( REMARK The set value is saved an d is displayed when the next ad justment is m ade to the clearance. If tha t value is to be used as it is, there is n o need to input the set value ag ain. If it is desired to abort the setting of the OSS clearance, pr ess return swi tch (7).

T his will return the set value to the original setting. 6. Adjust the clearance. 1) Use UP switch (4) or on the screen displa 2) Press input confirm preparations. "|" lamp (C) flashes. 3) Press input confirma adjustment. "|" lamp (C) lights u carried out. DOWN switch (5) to move the cu y to position (C). ation switch (6) to complete tion switch (6) again to carry ou p and the automatic adjustme