Komatsu — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE selector switch (3) to the S (semi-automatic) position. the machine monitor as follows. 1) Use UP switch (4) or DOWN switch (5) to move the cursor on the screen display to position (A). + display: Adjustment to open clearance - display: Adjustment to close clearance 4 - 41 5. Set clearance adjustmen 6. Check that mode monitor changed to S (semi-autom (D) of the machine monitor has atic) mode, then input clearance value (A) for the amount to change the present clearanc e on 2) Press input confirmatio n switch (6). (A) starts flashing and numeral input window ( screen.

B) is displayed at the top left of the 3) Use UP switch (4) or decrease the value on desired set value. DOWN switch (5) to increase or the display and adjust to give the The numerical value ca in a range of 50 to 150 n be set in units of 1 mm (0.039 in) mm (2.0 to 5.9 in). If the UP switch (4) or DOWN switch (5) is kept pre ssed continuously, the set v alue will increase or decrease in units of 10 mm (0.4 in). 4) After inputting the set v alue for the adjustment, press i nput confirmation switch (6) to set the input value. 7. Adjust the clearance. 1) 2) 3) Use UP switch (4) or D on the screen display t OWN switch (5) to move the cursor o position (C). Press input confirmat preparations.

"|" lamp (C) flashes. ion switch (6) to complete the n switch (6) again to carry out the Press input confirmatio adjustment. "|" lamp (C) lights up. 8. "|" l amp (C) goes out to sh ow that the clearance adjustm ent is complet