Komatsu — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE TOGGLE PLATE REMARK 4 - 46 Replace if wear di mension (A) is approx. 5 mm (0.197 in) on one side. Replace also if the wear is on one s ide as s hown in the diagram. Use the wear to lerance of toggle sheet (2 ) and toggl e plate (1) as a guideline f When replacin cover also at th If noise is gene rated between toggle shee t (2) and to ggle p late (1), the noise m ade when toggle plate (1) rolls on the surfac e of the toggle she et has no effect on the machine i tself.

If a knocking noise is generated, check if ten sion spring set length (B) is the speci (For details of the t ension spring set length, s ee "CHEC K OF J AW CRUSHER AND R ELATED ACCESSORIE S (PAGE 3 -63)".