. ATTACHMENTS, OPTIONS RADIO CONTROL UNIT REMOTE CONTROL OPERATION CHECK BEFORE STARTING OPERATION WARNING REPLACE, CHARGE BATTERY WARNING 6 - 11 o prevent mistaken transmissi on, carry out this check carefully before s tarting o peration efore st arting operations, c heck the following it ems. y functions on the transmitter. r parts are broken. If any broken part is found, do not carry out e transmitter is at the OFF position. e battery compartment at the bottom of the transmitter. he transmitter switch to the ON position. , the transmitter lamp will start to flash green. 1.
Chec k that there is no p roblem with the safet y functions on th Chec opera k that none of the switches or any othe en repaired. tions until it has be 2. Chec k that the transmitt er power switch on th e transmitter is at the O FF position. 3. Chec k that a charged ba ttery is installed in th e battery compartment at the b ottom of the transmitter 4. Turn the transmitter pow er switch key to set t he transmitter s witch to the ON position 5. The t ransmitter lamp wil l start to flash red. 6. Appr ox. 2 seconds after the lamp flashes red , the transmitter lamp w ill start t o flash green.
If the BATT lamp continues to flash red, the battery charge is low, s o take th e actio n given i n "REPLACE, CHARGE ERY (PAGE 6-11) ". er stop switch is OFF. 7. Chec k that the transmitt er stop switch is OFF ot carry out OTICE f the trans mitter stop switch is kept pressed, the work equipment will no t start o r stop. C ancel th e stop switch, then turn the ngine sta rting switch OFF and wait for at least 10 seco nds. 8. Turn the engine starting switch ON again an d start operation of the w ork equipment. (This is to check, so do not start the engine.) 9. Set th e remote control s elector switch on the machine control box to the REMOTE C ONTROL position. 0.
Chec k that the yellow ro tating lamp at the fro nt of the machin e is ligh ted up. 1. Press the transmitter ho rn switch and check that the machine horn s ounds. 2. After completing the che cks, turn the transmi tter power switc h ON an d set th e remot e control selector switch to the Start PANEL position. llows. the operation as fo f the rema ining charge in the bat tery on the transmitter b ecomes low, the re d lamp w ill start t o flash. I f this happens, do as follows mmediate ly. the transmitter to set the machine in a safe place or in a safe condition within 30 seconds. seconds, the transmitter will switch to emergency stop status.
e transmitter power switch key on the transmitter to the OFF position to turn the transmitter OFF. Operate the transmitter to se t the machine in a safe place or in a safe c ondition within 3 0 second After 30 seconds, the transm itter will switch to emer gency stop status. Turn th e transmitter power s witch key on the transm itter to the OFF po sition to turn the transmit ter OFF. f the tran smitter lamp flashe s red, replace the ba ttery as follows.