.
ATTACHMENTS, OPTIONS MUCK DISCHARGE CONVEYOR FAILURES AND CORRECTIVE ACTIONS 6 - 26 Problem Main causes Remedy Conveyor belt Not operable Electric circuit fault Correct wiring Snaky movement Misalignment of rollers and improper mounting Debris transport direction Debris stuck to rollers (Likewise wire or string winding about rollers) Belt elongation Belt bending, or not installed properly in endless processing Frame twisting and bending Frame not poised evenly (Belt is deflected to lower side) Adjust roller mounting angle Load debris evenly in the middle of fan belt, after making sure that the machine is kept level on the ground Clean roller periphery Adjust belt tension with take-up Retry endless processing, or replace belt with new one Correct twisting and eccentricity at time of assembly or machine installation Correct twisting and eccentricity at time of assembly or machine installation Abnormal wear on backside Slip on motor pulley (or drive pulley) surface Debris or foreign object stuck in between belt and pulley (Foreign objects stuck on pulley surface) Correct belt elongation with take-up a.
Remove foreign objects (Remove sticking) b. Improve loading conditions at loading part Damage (fissure in vertical direction) Remove foreign objects Insert rollers into bracket correctly Replace faulty rollers Device to alleviate shock, or ensure right load Do not let such materials be Abnormal elongation Return to normal tension Replace with heat-resistant belt Ensure proper load Warpage Remove cause for oil to mix with debris, or use oil-resistant belt Use heat-resistant belt Use acid-resistant or