. FOREWORD INTRODUCTION CRUSHER (PAGE FRONT/REAR, LEFT/RIGHT DIRECTIONS OF MACHINE from the (F) (L) (S) Front Left Sprocket (Re) (Rt) (D) Rear Right Places for operation BREAKING IN THE NEW MACHINE NOTICE Your Komatsu machine has been thoroughly adjusted and tested before shipment from the factory. However, operating the machine under full load before breaking the machine in can adversely affect the performance and shorten the machine life. Be sure to break in the machine for the initial 100 hours (as indicated on the service meter). Idle the engine for 5 minutes after starting it up. Avoid operation with heavy loads or at high speeds.
Immediately after starting the engine, avoid sudden starts, sudden acceleration, unnecessary sudden stops, and sudden changes in direction. 1 - 7 INTRODUCTION This Komats u machine is designed to be use d main ly for th e following work Crushing O peration For details 3-111)". to the section"SCOP WORKS USING MOBILE This manual indicates an aft of as viewed operator's platform in t he foreword traveling d irectio n and wi th the sprockets turned to the front side.