. OPERATION EXPLANATION OF COMPONENTS FUEL CONTROL DIAL 3 - 33 STARTING SWIT Starting switch (1) is used to start or st (A): OFF positio The starting sw the electrical sy stem is cut, and the en (B): ON position Electricity flows to the charging circuit and lamp circuit . Keep t key at this posit ion when the engine is (C): START pos This is the posi gine. Keep the key position when c release the ke ranking the engine, an d when the engine star y immediately. The k heating) position (D): HEAT (pre- Turn the key to this position when star ting the engine i n cold w eather When the key is turned to the HEAT (pr e-heating) p osition, the e ngine pre-heating mon itor lights u p.
Keep th e key at this position until the engine pre-he ating monitor g oes out. Whe n the engine pre -heating m onitor goe s out, release the key return the START position of e lectricity NOTICE Set the engine starting switch key to ON position afte r confirming th e fuel c ontrol dial is at the low idling ( MIN) positio When starting the work, set the fuel cont rol dial to the MA X position . This dial (2) adj usts the engine speed and output. (a) Low idling ( MIN): Dial turned fully t (b) Engine at full speed (MAX): Dial tur ned fully to righ