INSTRUMENTS AND CONTROLS 2 JOYSTICK LOCKING LEVERS (only for the version with servo-assisted backhoe) q Before operating the locking levers to adjust the position of the joysticks, lower the work equipment to the ground and stop the engine. q Adjust the joysticks remaining seated in the driving position. q Before rotating the joysticks, make sure that the safety button is in locking position (LED on) (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON"). The levers (2) are positioned under the arm supports and allow the corresponding joysticks to be released. It is possible to turn both joysticks to the desired operating position by simply pressing the levers (2).
Once the desired position has been reached, release the levers to lock the joysticks. IMPORTANT q The joysticks must always be turned moderately, trying to accompany them until they reach the desired position. q At the end of digging operations with the backhoe, always shift both joysticks back to the vertical position. 3 ARM SUPPORT ADJUSTING KNOB (only for the version with servo-assisted backhoe) q The operator must adjust the arm supports while seated in the driving position, before starting work and with the machine completely still. q Before carrying out this operation make sure that the servo control locking button is in locking position (LED on) (see "3.3.2 pos.
12 - SERVO CONTROL LOCKING BUTTON"). These knobs allow the corresponding arm supports (A) to be positioned at the desired height. To release and adjust the arm supports, turn both knobs (3) counterclockwise, as indicated by the arrow (B). After the adjustment, turn the knobs (3) clockwise, until locking them as indicated by the arrow (C). IMPORTANT q After carrying out the adjustment, make sure that the knobs (3) and the arm supports (A) are fixed. 115 WARNING WARNING