USE OF THE MACHINE 3.6.5 HOW TO MOVE THE MACHINE q Before moving the machine, make sure that you know the control functions and all the relevant safety regulations perfectly. q The operator must be seated in the driving position with fastened safety belt and must have checked the position of the rear-view mirrors. q Before moving the machine, make sure that there is no one within the range of movement of the machine and that there are no obstacles in the surrounding area. q Be extremely careful when engaging the reverse and make sure that there are no persons, other equipment or obstacles in the way. q The brake pedals must be connected with the special pin provided for this purpose.
Before moving the machine, check the instruments, warm up the engine, heat the hydraulic oil, and make sure that the stabilizers have been raised and that both the front bucket and the backhoe are in transport position. The control levers must be in the neutral position (N). At this point, release the parking brake. Select: 1 - the travel direction, by shifting the control lever (1) forward (F) or backward (R). 2 - the gear by means of the gearshift lever (2). 3 - Accelerate gradually using the accelerator pedal. IMPORTANT q The travel direction must be selected with the engine at low rpm, in order to avoid abrupt accelerations.
q For the operation of the gearshift and its functions, see "3.3.6 pos. 5 - GEARSHIFT LEVER". q To shift gears, it is necessary to operate the declutch button (see "3.3.6 pos. 10 - DECLUTCH PUSH BUTTON"). q If it is necessary to shift down, first reduce the engine rpm and then shift down. q If it is necessary to reverse, slow down by putting on the brakes before operating the reverse gear lever. 137 WARNING