Komatsu — 3.9.1 LOADING AND UNLOADING THE MACHINE

TRANSPORTING THE MACHINE ON OTHER VEHICLES 3.9 TRANSPORTING THE MACHINE ON OTHER VEHICLES 3.9.1 LOADING AND UNLOADING THE MACHINE q The loading and unloading of the machine on-off the means of transport must be carried out on a flat surface and at a safety distance from the edges of ditches or from the roadside. q Block the means of transport by positioning wedges before and behind each wheel. q Make sure that the ramps are sufficiently strong; if necessary, reinforce them with blocks, in order to prevent any dangerous bending.

q Make sure that the ramps have the same length, are firmly anchored to the vehicle, are parallel to each other and perpendicular to the loading board; the distance between the ramps must be suitable for the wheel gauge of the machine. q Position the ramps with a maximum inclination of 15°. q Remove any trace of oil, grease or ice from the ramps and the loading board. q Do not change direction when the machine is already on the ramps; if necessary, go down and find the correct direction. 1 - The machine must get on the ramps with the front bucket (1) directed forward and lifted from the ground.

2 - After loading the machine on the truck, lower the front bucket to the ground, shift the gears into NEUTRAL and apply the parking brake. 3 - Lower the backhoe bucket (2) onto the vehicle, lower the stabilizers (3), lock the loader control and the backhoe control levers. IMPORTANT q On machines equipped with backhoe servo controls, the movements of the levers are inhibited by the front loader locking button (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON"). 4 - Stop the engine and remove the ignition key. !"#$ 5 - Secure the machine in the correct position by putting wedges (4) before and behind each wheel. 144 WARNING