PERIODICAL CHANGE OF THE SAFETY RELATED COMPONENTS 4.6 PERIODICAL CHANGE OF THE SAFETY RELATED COMPONENTS To ensure safety at any moment while driving and using the machine, the operator must carry out all the routine maintenance operations prescribed. Furthermore, the operator must periodically change the components indicated in the table in the following page, which are especially related to safety and fire-prevention rules.
These components are subject to wear and since it is particularly difficult to evaluate their conditions through simple routine maintenance, after a certain time interval it is advisable to change them independently of their state, in order to keep them efficient over time. Repair or replace these components immediately in case of failures or anomalies, even if the time interval prescribed for their change has not elapsed yet. If the pipe clamps show signs of deterioration, like deformations or cracks, change them together with the pipes.
In addition to the periodical change of the components listed in the following page, the inspections described here below are to be carried out on the hydraulic pipes. In case of anomalies, carry out the necessary adjustments and changes, or adopt any other measure required. Type of check Items to be checked Before starting the engine Leakages from joints, hydraulic pipes or fuel pipes Periodically (monthly) Leakages from joints, hydraulic pipes or fuel pipes. Damaged hydraulic or fuel pipes (cracks, wear and tear) Periodically (yearly) Leakages from joints, hydraulic pipes or fuel pipes.
Deteriorated, twisted, damaged hydraulic or fuel pipes (cracks, wear and tear) or pipes in contact with other parts of the machine 183