Komatsu — 4.8.6.a CHECKING THE HYDRAULIC OIL LEVEL

MAINTENANCE PROCEDURES 4.8.5 MAINTENANCE AFTER THE FIRST 50 HOURS OF OPERATION (Only for machines in which synthetic biodegradable oil type HEES is used) The following maintenance operation must be carried out after the first 50 hours, together with the maintenance operations to be carried out “EVERY 50 HOURS”. a - CHANGE THE HYDRAULIC OIL DRAIN FILTER For further details, see section "EVERY 500 HOURS". 4.8.6 MAINTENANCE EVERY 50 HOURS OF OPERATION 4.8.6.a CHECKING THE HYDRAULIC OIL LEVEL q positioned on level ground and in lubricating position.

q If it is necessary to top up, stop the engine and eliminate the residual pressure from the equipment circuits (by moving the controls more than once) and from the tank (by slowly loosening the filler cap (2)). The oil level must be visible through the window (1) provided on the tank and must be included between the MIN. and MAX. marks. If the level is near the MIN. reference mark, open the engine hood (see "3.5.1 ENGINE HOOD") and top up through the filler (2) using the prescribed type of hydraulic oil (see "4.3 FUEL, COOLANT AND LUBRICANTS"). Put back the filler cap (2) and close the engine hood. IMPORTANTE q Do not exceed the MAX. reference mark.

This would damage the hydraulic circuit and cause the oil to overflow. q If you notice a constant, unusual decrease in the oil level, contact your Komatsu Dealer. 205 AVVERTENZA