TPD1317e Chapter 7 7.5 Instrument Panels Panel Set-up Information. Two types of panel are available, providing different levels of instrumentation. The ‘Instrument Panel’ shown in Figure 13 includes:- All panels are supplied configured as master panels. Master - Slave Configuration. In the event that more than one panel is being used to control one engine then there is the choice of making one of them a slave to the other (master) panel. Where there is one panel in the wheelhouse and another on the flybridge then there is the option of making the control functions on the flybridge panel (slave) only operational when the wheelhouse panel (master) is switched on. 1.
Panel illumination level switch 2. Water in fuel warning lamp 3. Charge warning lamp The illustration below shows the removable link on the rear of the panel. To convert a panel to slave remove the link from the master (M) terminal and refit to the slave (S) terminal. 4. Voltmeter 5. Heat/start switch 6. On/off switch 7. Stop switch 8. Oil pressure gauge 9. Low oil pressure warning lamp 10. Tachourmeter Note that one panel must always be a master and that no more than two panels should be connected to one engine without reference to Sabre Engines Ltd. 11. Water temperature gauge Tachometer Set-up Procedure. 12.
High water temperature warning lamp All panels are supplied set to match their associated engine. In the event that the tachometer needs re calibrating the following procedure should be followed. The circuit diagram of this panel is shown in Figure 14. a) Ensure that the panel is connected to it’s interconnecting lead leading back to the engine. b) Insert a probe into the rear of the tachometer as shown in the drawing below. Lightly press the set-up switch within the hole and at the same time switch ON the panel. c) Keeping the set-up switch held down observe the LCD display on the front of the tachometer. When the word PULSE is displayed release the set-up switch.
d) A number will now be visible and individual digits will start to flash. The flashing digit can be adjusted by depressing the operating set-up switch to index the number to the required value. Repeat this for all digits as required. e) When complete await for the display to revert back to engine hours. f) Switch panel to OFF. Note to establish the correct setting for the tachourmeter the following formula should be applied. Diameter of Alternator Driven Pulley X 6 = Number of Pulses. Diameter of Alternator Drive Pulley Figure 13 - Instrument panel Page 47