Perkins — Perkins Sabre Marine Engines Installation Manual

TPD1317e Chapter 10 10.2 Block Heater - for 6 cylinder engine models Return from block heater Connections are to suit 5/8” bore hose Supply to block heater Block heater Figure 2 - Block heater connection points. A mains powered cylinder block heater may be fitted to keep the engine warm when the boat is stored in low temperatures. A suitable heater may be ordered as part of the engine assembly, or may be fitted later. Figure 2 shows the connection points, the supply being taken from a hole in the cylinder block tapped 1/4” - 18 NPSI and the return from a hole in the cylinder head tapped 1/2” - 14 NPSI. For most purposes a 500W heater will be satisfactory.

If the heater is ordered at the same time as the engine, it will be attached to the engine. If fitted later it may be more convenient to mount the heater on the engine bearer. The hose connections to the block heater must be of a radiator or heater hose quality, and must be installed so that chafing will not occur. Caution: The hoses connecting the block heater to the engine are part of the closed engine cooling system. Failure of a hose will lead to the engine overheating! Page 65