Komatsu — 3.2.2 Switches

Operation 3.2 Explanation of components 3. Transmission shift mode selector switch This switch (3) is used to change the shift point when the AUTO SHIFT/MANUAL selector switch has been switched to auto shift. At each of the L, H positions, the system switches to auto shift and the auto shift pilot lamp on the machine monitor lights up. Normally, set to auto shift. MANUAL position: System is set to manual shift and speed range is a position selected by gearshift lever GK038023 L position: Travel speed when shifting up is low (flat ground, normal travel) H position:

Travel speed when shifting up is high (traveling uphill, traveling at high speed) If it is set to the L position when the work is mainly operations on flat ground, it is possible to shift up when the engine speed is low. This is effective in reducing fuel consumption. For details of the manual shift, see "Manual shift (3-57)". For details of the auto-shift, see "Automatic shift (3-57)". 4. Transmission cut-off switch b cut-off switch to the OFF position, depress the brake pedal, then gradually depress the accelerator pedal and release the brake slowly to allow the machine to start off. This makes it possible to prevent the machine from rolling back.

a GK038024 Press this switch (4) to turn on and off the transmission cut-off system. When the switch is pressed, the pilot lamp lights up and the sys- tem is turned ON. The transmission is shifted to neutral at the adjusted brake pedal depression position. Normally, keep the switch at the ON position. For details of the method of adjusting the cut-off position, see "Adjusting transmission cut-off position (3-124)". Position (a): OFF The brake pedal acts in the normal way for the brake. Position (b): ON In addition to acting in the normal way for the brake, the brake pedal returns the transmission to Neutral at the same time.

The brake pedal position where the cut-off system is actuated can be adjusted by using the transmission cut-off set switch on the right switch panel. WA470-6H – VEAM946100 3-43 WARNING WARNING