Operation 3.3 Operation Check oil level in engine oil pan, add oil Engine parts and oil are at high temperature immediately after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Open the inspection cover of the right side at the rear of the machine. 2. Take out the dipstick (G) and wipe off the oil with cloth. 3. Completely insert dipstick (G) fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dip- stick (G). If the oil level is below the L mark, add oil through oil filler (F).
F G P If the oil is above the H line, open drain valve (P), drain the excess engine oil, then check the oil level again. GK047014 5. If the oil level is correct, tighten oil filler cap (F) securely and close the inspection window. REMARK When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. GK032178 WA470-6H – VEAM946100 3-93 WARNING WARNING