Operation 3.3 Operation Adjustment Seat adjustment When adjusting the position of the operator's seat, always set the work equipment lock lever to the LOCK position to prevent any accidental contact to the control levers. ! Always adjust the operator's seat before starting each oper- ation or when the operators change shift. ! When adjusting the seat, put your back against the backrest and adjust to a position where the brake pedal can be fully depressed. (A) Horizontal adjustment Lift lever and move seat forwards/backwards. Release the lever to lock the seat.
(B) Height and Slope adjustment Pull lever and adjust the seat position in height and slope by loading/unloading the front/rear seat cushion area. (C) Backrest adjustment Adjust the position of the backrest by pulling the lever whilst a load is applied to the backrest. (D) Weight adjustment Push button to adjust the suspension to the driver's weight in the middle swing position. B D E A C Careful! No height adjustment. (E) Lumbar support Push buttons to inflate/deflate the air chambers of the integrated pneumatic system. This allows the operator to match the shape of the backrest indi- vidually to the body contours. WA470-6H – VEAM946100 3-99 WARNING WARNING