Komatsu — Load and carry operations

3.3 Operation Operation Leveling operation NOTE ! Always operate the machine in reverse when carrying out leveling operations. If it is necessary to carry out leveling operations when travel- ing forward, do not set the bucket dumping angle to more than 20 degrees. ! Turn the E.C.S.S. switch (option) OFF when carrying out lev- eling operations. 1. Scoop soil into the bucket. Move the machine backward while spreading soil from the bucket little by little. GK032210 2. Go over the spread soil with the bucket teeth touching the ground and level the ground by back-dragging. 3.

Scoop some more soil into the bucket, put the lift arm control lever in FLOAT position, level the bucket at ground level, and smooth the ground by moving backward. Pushing operation Never set the bucket to the DUMP position when carrying out pushing operation. When carrying out pushing operations, set the bottom of the bucket parallel to the ground surface. Load and carry operations ! When carrying a load, lower the bucket to lower the center of gravity when traveling. ! When the machine is traveling or the work equipment is raised, the moment that the E.C.S.S. switch is turned ON, the work equipment will move. !

If operations are carried out with the E.C.S.S.switch left at the ON position, the moment that the travel damper is actu- ated, the work equipment will move. GK032211 The load and carry method for wheel loaders consists of a cycle of scooping -> hauling -> loading (into a hopper, truck, etc). Always keep the travel path properly maintained. When using the load and carry method, see "Precautions for using load and carry method (3-148)". 3-134 WA470-6H – VEAM946100 CAUTION CAUTION WARNING WARNING