Operation 3.7 Troubleshooting 3.7.3 If battery is discharged ! When checking or handling the battery, stop the engine and turn the starting switch key to the OFF position. When removing, disconnect the cable from the ground (-) terminal first. ! The battery generates hydrogen gas, so there is a hazard of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause sparks. ! Battery electrolyte is dilute sulphuric acid, and it will attack your clothes and skin. If it gets on your clothes or on your skin, immediately wash it off with a large amount of water. If it gets in your eyes, wash it out with fresh water and consult a doctor. !
When handling batteries, always wear protective goggles and rubber gloves. When installing, connect the cable to the positive (+) terminal first. ! When removing the battery, first disconnect the cable from the ground (normally the negative (-) terminal). When install- ing, install the positive (+) terminal first. If a tool touches the positive terminal and the chassis, there is danger that it will cause a spark, so be extremely careful. ! If the terminals are loose, there is danger that the defective contact may generate sparks that will cause an explosion. ! When removing or installing the terminals, check which is the positive (+) terminal and which is the negative (-) termi- nal.
GK032229 WA470-6H – VEAM946100 3-169 WARNING WARNING