Komatsu — Starting engine with booster cable

Operation 3.7 Troubleshooting Starting engine with booster cable When starting the engine with a booster cable, do as follows: Precautions when connecting and disconnecting booster cable ! When connecting the cables, never contact the positive (+) and negative (-) terminals. ! When starting the engine with a booster cable, always wear safety glasses and rubber gloves. ! Be careful not to let the normal machine and problem machine contact each other. This prevents sparks from gen- erating near the battery which could ignite the hydrogen gas given off by the battery. ! Make sure that there is no mistake in the booster cable con- nections.

The final connection is to the engine block of the problem machine, but sparks will be generated when this is done, so connect to a place as far as possible from the bat- tery. GK032231 ! When disconnecting the booster cable, take care not to bring the clips in contact with each other or with the machine body. NOTE ! The size of the booster cable and clip should be suitable for the battery size. ! The battery of the normal machine must be the same capac- ity as that of the engine to be started. ! Check the cables and clips for damage or corrosion. ! Make sure that the cables and clips are firmly connected. !

Check that the safety lock levers and parking brake levers of both machines are in the LOCK position. ! Check that each lever is in the NEUTRAL position. WA470-6H – VEAM946100 3-171 WARNING WARNING