Komatsu — Chassis

3.7 Troubleshooting Operation Chassis ! ( ): Always contact your KOMATSU distributor when deal- ing with these items. ! In cases of abnormalities or causes which are not listed below, please contact your KOMATSU distributor for repairs. Problem Main causes Remedy Transmission Axle Brake 3-174 WA470-6H – VEAM946100 Engine is running but machine does not move ! Parking brake is applied ! Directional lever is not shifted properly ! Lack of oil in hydraulic tank ! Release parking brake ! Shift lever properly ! Add oil to specified level. See WHEN REQUIRED Even when engine is run at full throttle, machine only moves slowly and lacks power ! Lack of oil in hydraulic tank ! Screen is colgged !

Add oil to specified level. See WHEN REQUIRED ! Disassemble, clean Oil overheats ! Too much oil or too little oil ! Machine is not traveling in correct speed range ! Torque converter is stalled for long periods ! Engine is overheating ! Add or drain oil to specified level. See WHEN REQUIRED ! Place in correct speed range ! Reduce stall time ! (Check engine) Noise generated ! Lack of oil in transmission case ! Add oil to specified level. See WHEN REQUIRED Noise generated ! Lack of oil ! Improper oil used (for machines with limited-slip differential) ! Add oil to specified level. See WHEN REQUIRED ! Change to specified oil Brake is not applied when pedal is depressed !

Disc has reached wear limit ! Defective hydraulic system ! Lack of oil ! Air in brake line ! (Replace disc) ! Add oil to specified level. See EVERY 100 HOURS SER- VICE ! Bleed air. Brake drags or not applied ! Vent hole of brake valve is clogged ! Clean Brakes squeal ! Disc is worn ! Large amount of water in axle oil ! Deteriorated axle oil due to over- use of brake ! (Replace disc) ! Change axle oil ! Change axle oil