4.9 Service procedure Every 500 hours service Maintenance Replace fuel pre-filter cartridge ! Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. ! High pressure is generated inside the engine fuel piping sys- tem when the engine is running. When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before replacing the filter. ! Do not bring fire or sparks near the fuel. ! Be careful when opening the air bleed plug in the fuel filter head. It is still under pressure, so fuel may spurt out. NOTE !
Genuine KOMATSU fuel filter cartridges use a special filter that has highly efficient filtering ability. When replacing the filter cartridge, always use a genuine KOMATSU part. ! The common rail fuel injection system used on this machine consists of more precise parts than the conventional injec- tion pump and nozzle. If any part other than a genuine KOMATSU filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid using substitute parts. ! When carrying out inspection or maintenance of the fuel sys- tem, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. !
Container to catch the fuel ! Filter wrench 1. Open the engine side cover on the right side of the chassis. 2. The fuel pre-filter forms one unit with the water separator and is installed at the center of the engine. 3. Set the container to catch the fuel under the filter cartridge (1). 4. Using the filter wrench, turn cap (2) of the water separator to the left to remove it. (This cap is used again. If it is damaged or broken, replace it with a new part.) 5. Using a filter wrench, turn the filter cartridge (1) to the left to remove it. GK047038 GK047038 1 4-70 WA470-6H – VEAM946100 WARNING WARNING