4.9 Service procedure Maintenance Every 1000 hours service NOTE ! Do not fill the filter cartridge with fuel. ! Cap (A) is installed to prevent dirt from entering the inside of the filter cartridge. A 4. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter car- tridge is too loose, fuel will also leak from the packing, so always tighten the correct amount. GK038118 When tightening with a filter wrench, be extremely careful not to dent or damage the filter. 5.
After completing the replacement of fuel main filter cartridge (1), bleed the air. Bleed the air as follows: 1. Fill the fuel tank with fuel. 2. After replacing filter cartridge (1), loosen air bleed plug (2). Do not loosen the plug at the filter stand of the fuel prefilter. If it is loosened, air is not bled. 3. Loosen wing bolt (4) which is fixing lever (5) of priming pump (3). Move lever (5) up and down to let fuel flow out of air bleeding plug (2) until bubbles do not come out any more. 4. Tighten air bleeding plug (2) and then tighten wing bolt (4) of priming pump (3) securely to lock lever (5). 5.
After replacing the filter cartridge, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage of fuel, check the tightening of the filter cartridge. If there is still leakage of fuel, follow Step 1 and 2 to remove the filter cartridge, then check the packing surface for damage or foreign material. If any damage or foreign material is found in the packing, replace the cartridge with a new part, then repeat Steps 3 - 10 to install the filter car- tridge. GK047038 1 5 4 GK047046 WA470-6H – VEAM946100 4-73