Komatsu — Replace corrosion resistor cartridge

4.9 Service procedure Every 1000 hours service Maintenance Lubricating 1. Using a grease pump, pump in grease through the grease fittings marked by the arrows. 2. After greasing, wipe off any old grease that was pushed out. 3. Center hinge pin (2 places) 4. Drive shaft center support (1 place) GK043202 Check of engine air intake piping clamps for looseness Please ask your KOMATSU distributor to check the tightening of the clamps between the air cleaner - turbocharger - aftercooler - engine. Replace corrosion resistor cartridge 1. Close a valve (1) of the corrosion resistor at two points. 2. Using a filter wrench, turn cartridge (2) to the left to remove it. 3.

Apply engine oil to the sealing surface of a new cartridge, then install it to the filter holder. 1 4. Bring the packing surface into contact with the seal surface of the filter holder, then tighten it further approx. 2/3 turn. 2 5. Open a valve (1) of the corrosion resistor at two points. GK047051 4-76 WA470-6H – VEAM946100 GK043201