Technical Data 5.4 Limit values for slopes 5.4 Limit values for slopes Maximum slope angle for machine operation If operating the machine on a slope, its angle must not exceed 26° uphill, 35° downhill or 16° sideways. If you angle the machine at more than 35° during operation, the motor, transmis- sion, hydraulic system or axles, will not be supplied with suffi- cient oil and can be damaged. A uphill 26° B downhill 35° C sideways 16° Tipping angle, theoretically The tipping angle is a calculated value. This states the angle at which the machine at rest can stand on a slope without tipping over.
You must not work with the machine at these angles as the motor, transmission, hydraulic system or axles, will not be sup- plied with sufficient oil and can be damaged. The specified angle refers to the transport position. The angle changes if you raise or lower the work unit. A uphill with operating load uphill without operating load 65,3° 51,8° B downhill with operating load downhill without operating load 39,9° 57,9° C lateral with operating load lateral without operating load 45,0° 43,6° GK100372 WA470-6H – VEAM946100 5-7