Note If bearing seizure or severe scoring is present, the camshaft bearings in the cylinder head can be enlarged by 0.5 mm and camshafts with oversize bearing journals installed. These camshafts have different code numbers (05215 and 220). If the rocker arm bearing brackets are equipped for enlarging without the rocker arm shafts, the fastening bolts of the bearing brackets must be tightened to max. 15 Nm otherwise the bores for the rocker arm shafts will be distorted. When machining the basic bores, ensure that the half- bores for mounting the cylinder head cover gasket or the sealing disc at front and rear on the cylinder head are not widened.
After widening the basic bores, the edges at the mating face of the cylinder head bracket (A) or at the mating face of the cylinder head (B) on the camshaft bearings 1 to 4 must be machined in accordance with the specified dimensions. If the edges are not machined, the lubrication film will tear at these points, causing damage (seizure) to the camshaft bearings. 01.0904 - 41912