03-316 Removal and installation of pistons Preceding work: Removal of engine (01-030). Removal of cylinder head (01-415). Removal of oil pan (01-310). 33 32 34 373 35 - 26 Q% 28 II Conrod bearing cover (26) . . . . . . . . . . . . . . . . . unbolt, bolt on, 30 Nm and 90” angle of rotation torque. Do not mix up top and bottom bearing shells. Pay attention to matching of conrod and bearing cap (step 12). Conrod bolt (28) . . . . . . . . . . . . . . . . . . . . . . . . check (03-310). Locking ring (37) Piston (32) and . conrod (25) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . push out of crankcase upwards. . remove (step 3) and insert (step 9). Piston pin (36) . . .
. . . . . . . . . . . . . . . . . . . . . . press out and press in by hand (step 8). Installation lnstructlon Insert conrod into piston so that the chamfered splash bore in the small end bearing with the arrow in the piston crown are pointing in direction of travel; do not heat piston. 03.0905 - 316.‘1