mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

Inspection of hardening Corrosion protection To achieve proper hardening, check the setting Crankshafts which are not immediately re- of the hardening system by metallographic installed, must be oiled with initial operation ground surfaces. engine oil (SAE 30). These can be removed from test hardening operations on scrapped crankshafts. Check hardening by etching the surface of the journal with a 2 % alcoholic nitric acid (HNOs). No dark spots should appear on the surface of the journal. Non-hardened radii change to a dark colour. By contrast, the hardened radii must be just as bright as the surface of the journal.

As a comparison, it is recommended to perform etching on a metallographically tested journal. Following this, carefully wash off the nitric acid with alcohol. 03.0905 - 31&8