mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Matching crankshaft bearings, installing crankshaft Note These operations should be performed if the dimensions of the crankshaft journals or of the basic bearing bores in the crankcase and at the conrod are not known, e.g. if the crankshafts have been remachined. All the bearing covers fit into the side of the crankcase (arrows) and are attached each with 2 bolts. The fit (arrows) is offset from the center so that the bearing covers can only be installed in one position.

I In addition, they are marked from front to rear with the code numbers 1, 2, 4 and 5 (arrows), with the exception of the thrust bearing covers,, and must not be interchanged or replaced. I I pe--d4 3 0 0 0 0 0 n ------Jo n I 1 Install crankshaft bearing covers without bearing shells. 2 Oil fastening bolts for crankshaft bearing covers and tighten to 90 Nm (hexagon bolts) or 55 Nm initial torque and angle of rotation torque (stretch bolts), respectively. 3 Measure basic bore in two planes in the direction A, B and C (conicity). If a basic bore exceeds the specified value or is conical, dress the mating face of the bearing cover on a surface plate to max. 0.02 mm. 03.0905 - 32019