Removal and installation 1 Press radial seal out of the end cover with a screwdriver. When performing this step, ensure that the crankshaft flange and the mounting hole in the end cover are not damaged. Cover over crank- shaft flange with a rag. 2 Check running surface for radial seal on the crankshaft for signs of damage. 3 Clean mounting hole in the end cover for the radial seal, deburr if necessary. 4 Screw inner part of installation tool onto crankshaft flange. 5 Oil sealing lip of radial seal. Caution! Do not use any grease. Grease prevents the inclined webs on the sealing lip from repositioning. 6 Install radial seal (arrow) over the inner part of the Installation tool. 03.0905 - 32713