The crankshaft setting 20” after TDC is de- termined from the piston travel, starting from ignition TDC of No. 1 piston. The piston travel is measured either with the intake valve of No. 1 cylinder mounted on the piston crown and dial gauge or, if the cylinder head is removed, directly by mounting the dial gauge pin on the piston crown. PO3.2026.13 Checking 1 Remove and install fan shroud (1) and fan (75) tightening torque of bolt (SO), 25 Nm. 2 Set engine to ignition TDC of No. 1 cylinder. 3 Remove and install rocker arm bearing bracket (61) by unscrewing oil pipe. Tightening torque of bolts (63), 21 Nm. 03.0905 - 34514