With the distributor ignition (DI EZL), the flywheel or the flex plate was provided with two segments (A) offset by 180“. As the segments rotate past the position sensor this produces an alternating voltage as a result of induction. If the segments are damaged, replace the fly- wheel or the flex plate. - formerly Flywheel of manual transmission Flex plate of automatic transmission Removal and installation 1 Remove end cover (30) from the rear of the oil pan. Remove bolts (arrows), bolt in, tightening torque 10 Nm. Press off end cover with screwdriver, fit on. 2 Attach retaining lock 601 589 02 40 00 with both bolts (arrows). The pins on the retaining lock must mesh into the ring gear teeth.
3 Unscrew stretch bolts (18). Take off flywheel or driven member with bonded spacer disc (44a) and spacer disc (44). 03.0905 - 41 o/4