The hydraulic valve clearance compensating elements consist of the following components: l Set bolt (64) with oil reservoir chamber (a) as well as return and venting bores (c) and a ball valve, consisting of a 5 mm 5 8 - (63), telescopic type ball bearing traveler (61) and compression spring (62). 0 ball 5 5 - l Guide sleeve (59) with working chamber (b), compression spring (60) and sealing cap (65). / P po5-0033-15 The element can drop completely when the engine is not running and the cam tip presses against the rocker arm and thus also against the element.
Oil expelled from the working chamber (b) flows via the annular gap (built-in clearance between guide sleeve and set bolt) to the reservoir chamber (a). When the cam tip moves away from the rocker arm, the set bolt (64) is relieved of load and the compression spring (60) presses the set bolt upwards until the rocker arm contacts the cam. The vacuum, arising from the upward movement of the set bolt, opens the ball valve, and oil flows out of the reservoir chamber (a) into the working chamber (b). As soon as the cam presses against the rocker arm and thus loads the set bolt, the ball valve closes.
The oil in the working chamber acts as an “hydraulically rigid connection” and the respective valve is opened. When the engine is running, depending on engine speed and cam position, the set bolt is only pressed slightly downwards. 05.0906 - 211/4