mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

Dial gauge (01) . . . . . . . . . . . . . . . . . . . . . . . . . Insert and put tip vertically on valve spring retainer with 3 mm pretension (small pointer) (Number 6). Crankshaft . . . . . . . . . . . . . . . . . . . . . . . . . . . Turn in the direction of rotation of the engine until the small pointer on the dial gauge has travelled back by 2 mm (valve stroke). The value now read off on the vibration damper must agree with the value in the table “Intake valve open” (Number 7). Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . Put engine on ignition TDC of No.1 cylinder (Number 8). Chain tensioner locknut (40) . . . . . . . . . . . . . .

Unbolt and bolt up, replace sealing ring Oil pressure pump . . . . . . . . * . . . . . . . . . . . . Unbolt, set to one side with lines connected (Number 10). (41), 70 Nm (Numbers 9 and 19). Camshaft timing gear . . . * . . . . . . . . . . . . . . . Align with timing chain. Unbolt camshaft timing gear (Numbers 11 to 13 and 15). Woodruff key (6) . . . . .., . . . . . . . . . . . . . . Select from table and insert (Numbers Camshaft timing gear . . . . . ., . . . . . . . . . . . Assemble, note color marking, only install set 14 and 15). bolt. Repeat tests (Numbers 6 and 7). Tighten set bolt (9). 80 Nm (Numbers 16 to 18).

Rocker arm bearing support and rocker arm with hydraulic valve clearance compensating element Dial gauge (01) and dial gauge (02) . . . . . . . . . . Detach. Install (Number 20). Proceed with installation in reverse sequence 05.0906 - 21512