5 Unbolt, bolt up camshaft timing gear, bolt (9a), tightening torque 80 Nm. Note color markings on camshaft timing gear and crankshaft gear. Note On vehicles with oil pressure pump remove driving disc sleeve (70). 6 Swing tensioner blade (22) for single roller chain inwards and remove from bearing pin (26), install. 7 On engines with double roller chain, drive out bearing pin (26) of the tensioner blade with the impact extractor 116 589 20 33 00 and extension 116 589 03 34 00. To do this cut an M6 thread approx. 10 mm deep on the bearing pin. Remove tensioner blade. 8 Check plastic support for wear, replace if necessary. PO5-2032-13 05.0906 - 330/4