Alternator (G2) Connector (327) ............. ............ . . . . . * . . . . . . . . unscrew, screw on, 30 Nm (step 6). . unplug at alternator, plug in (step 5). Bracket (156) .............. . . , . . . . . . . for alternator, unbolt, bolt on, 25 Nm (step 7). TDC pulse generator cable (1) . . . , . . . . unbolt, bolt on (step 8). If timing case cover has been replaced, the TDC pulse generator bracket must be adjusted (03345). Bracket (8) ................ . . . . . . . . for oil pump strainer basket, unbolt, bolt on, 25 Nm, (step 9). Timing case cover .......... . . . . . . . remove remaining bolts, take off timing case cover (steps 10 and 11). Do not damage cylinder head gasket:
replace cylinder head gasket if damaged. Timing case cover Mating surfaces ............ .......... . . . . . . . . . . . . . . . clean (step 12). . coat with sealant 001 989 25 20 and install timing case cover (steps 13 and 14). Use fitting tool 102 589 00 14 00 and spacer ring 102 589 01 14 00 for replacement of radial seal. Special tools 01 0904 - 21012