mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

To avoid any engine coolant mixing with the engine oil should a leak occur between crankcase and timing case cover, a groove (arrows) has been provided around the coolant inlet (h) to allow the coolant to flow to the outside. 39 3 8 2 3 1 O-ring 23 Rear stde of timing case cover Oil overpressure valve plug 38 Thrust piece 39 Bearing bush for Intermediate gear shaft f Oil pump g Mount for dlstnbutor h Coolant Inlet lgnltlon The timing case cover is always supplied as a replacement part with the oil pump installed, but without radial seal for the front of the crankshaft and without oil suction pipe with oil strainer.

Note A gasket for sealing the timing case must not be installed on these engines (with single belt drive). The timing case cover was modified effective 11107. The contours on the rear side have been lowered. This is detectible from the cast Part No. 102 015 11 01 on the front side of the cover. This timing case cover can also be installed on engines manufactured prior to this date. A Previous B Present version version POl-2621-13 01.0904 - 210/4