Instructions for use of servic 00-005 Complete Service Manual coverage for late model year Mercedes-Benz vehicles requires four individual manuals: Location of specific repair instructions First locate the Group No. in the Group Index. Individual groups are separated by an easily visible dividing page, which is followed by the job index page. The exact job required is found in the job index. The initial page of a typical job description appears as follows: Service Manual, Engine Service Manual, Chassis and Body Service Manual, Automatic Climate Control Electrical Troubleshooting Manual Throughout these manuals, the vehicles are identified by their chassis and engine numbers.
These numbers are made up of the first six digits of the respective serial number. For the actual location of chassis and engine numbers, see page 03-324 Replacement of front crankshaft radial seal Job Title appears on same line as Group No. 00-015’1. In cases where the repair instructions apply to all versions, only the first three digits of the respective number are referenced. For example, chassis 124 applies to all 124 models. However, chassis 124.051 would apply only to model 300CE with engine 104. Job No. Page No. Technical data, tightening torques and tools are listed at the beginning of each job. All dimensions are in metric units unless otherwise indicated.
Any part numbers given are only used for identification and differentiation between individual components, and are not intended for ordering purposes. Special Instructions AWarning Appears throughout service instructions indicating the possiblity of personal injury if procedures are not followed. Caution! Indicates possible equipment or vehicle damage if procedures are not followed. Note Provides helpful information for the described procedure. Installation note Provides detailed information during assembly. .oo - 005 11