Engine coolant hose (68) supply line for heater Engine wiring harness .................... . . disconnect, connect (step 9). disconnect, connect (steps 10 to 14). Brake booster vacuum line ................ disconnect, connect (step 15). Fuel lines ............................. disconnect, connect, dump overpressure (step 16). Air conditioning pipe group holder ........... disconnect, connect (step 17). Piston of No. 1 cylinder ................... set to ignition TDC (step 18). Alternator ............................. swing away to the outside (steps 19 and 20). Closing nut (40) . . . . . . . . . . . . . . . . . . . . . . . .
for chain tensioner, remove and install, replace sealing ring (41) (05310, step 21). Camshaft gear (4) Pressure oil pump (69) ....................... ................... unbolt, bolt on, place to the side with lines connected (step 23). mark relative to timing chain (step 22). Camshaft gear (4) ....................... unbolt, bolt on, 80 Nm, check TDC marking (steps 24 and 25). Hexagon socket bolts (77) ................. unbolt, bolt on with pin wrench 116 589 03 07 00, 25 Nm (reference value), (step 26). Cylinder head bolts (75) .................. unbolt, bolt in, check, tighten (steps 27, 31 to 33). Cylinder head (51) ......................
remove, refit, clean mating surfaces, replace cylinder head gasket (74) (steps 28 to 30). Refer to table for tightening torques. Tightening torques in Nm and angle of rotation torque Diagram for step-by-step tightening: refer to step 31 for order: Step-by-step tightening angle of rotatlon torque when engine cold I 1st stage 2nd stage I 3rd stage 01.0904 - 415~2 Hexagon socket bolts 25 Nm (reference value) -