AW1 ;R39b07 R70;070300 996 150266 AW1 ;R39611 R70;070300 1006 040266 CTM-7 (5-89) 2R3; 015 2& 110589 - .... , 3000 Series (HPR)-Hydraulic Pump 3c. Install shims (C) in inlet housing using a small amount of petroleum jelly to hold shims in place. 4. Install special packings (A and 8) and O-ring on center hub of pump housing, using small amount of petroleum jelly to hold packings in place. CAUTION: Failure to align the high-pressure passages will keep the pump in full stroke. This could result in hydraulic system damage and possibly a high-pressure leak which could cre- ate a risk of personal injury. 5.
Install inlet housing making sure high-pressure passage (8) in inlet housing and primary pump housing are aligned. 6. Install secondary housing on double bank pump making sure high-pressure passages align. 7. Install cap screws and tighten cap screws alternately to 200 N'm (150 Ib-ft). NOTE: Inlet housing does not have to be removed from pump for servicing pressure compensator. 1. Remove electric destroke solenoid (A) from inlet housing, if so equipped, to prevent damage to solenoid during pressure compensator valve repair. Litho in U.S.A. 15-26 NOTE Non-unitized design single bank pump is shown.
DISASSEMBLE, INSPECT AND ASSEMBLE PRESSURE COMPENSATOR VALVE- (NON-UNITIZED DESIGN) For SINGLE BANK pump, perform Step 3c. AllTractorManuals.com