John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

CTM-7 (5-89) 2R3 ; 020 03 110589 AW1;R39628 R70;070300 1026 110589 AW1;R39629, R39630 R70; 070300 1027 060188 D-Gear Tooth Tip E- Tooth Contact Area Auxiliary Charge Pump -2000 and 3000 Series A-Bearing Area B-Bushlng c-Gear Face Litho in U.S.A. 20-3 Drive Shaft OD ....... .. . . . . . . .. .. .. .. . . . . .. .. 16.023-16.033 mm (0.6308-0.6312 in.) 5. Inspect bushing (8) for excessive wear. pitting or flaking. Bushing ID . ..... . .. . . . ... . .. . ... ....... .. . ... 12. 385-12.411 mm (0.4876-0.4886 in.) 7. Inspect gear tooth tip (D) for knife edge and rolled tip. Replace gears as a set if this condition is found. 8. Inspect gear tooth contact area (E) for pitting.

scoring or metal transfer. Replace gears as a set if this condition is found. 9. Measure gear length and OD for excessive wear. Replace gears as a set if gears do not meet minimum specification. Gear OD . .. .... . . . . .... .. . .. . . . ... . .. . ....... .. . . . . . 43. 231 mm (1.7020 in.) Gear Length ........ ... ............ .. .. . ........... .. 44.805 mm (1.7639 in.) 4. Inspect drive gear shaft bearing area (A) for wear. 6. Inspect gear face (C) for radial scoring and wear. Install new gear if bushing requires replacement. MINIMUM ALLOWABLE GEAR SIZE NEW PART SPECIFICATION NEW PART SPECIFICATION AllTractorManuals.com