AW1;R39783 R70;070300 1148 050288 CTM-7 (5-89) 2R3 ; 110 os 110519 2000 Series (PR)-Operation and Tests ADJUST DEADHEAD (STANDBY) PRESSURE CAUTION: Escaping fluid under pressure can penetrate the skin causing serious injury. Re- lieve pressure before disconnecting hydraulic or other lines. Tighten all connections before applying pressure. Keep hands and body away from pinholes and nozzles which eject fluids under high pressure. Use a piece of cardboard or paper to search for leaks. Do not use your hand. If ANY fluid is Injected Into the skin, it must be surgically removed within a few hours by a doctor familiar with this type injury or gangrene may result. NOTE:
When operating or testing any hydraulic pump, it is good hydraulic systems practice to include a system relief valve set at 2070 kPa (20.7 bar) (300 psi) above deadhead pressure. IMPORTANT: Adjusting screw should be set to a mini- mum depth to prevent excessive dead- head pressure at start up. 2. Connect a 0-34 500 kPa (0-345 bar) (0-5000 psi) gauge. NOTE: System pressures val}'. Check applications or ma- chine manual for proper deadhead pressure setting. 3. Turn adjusting screw (A) in to increase deadhead pressure. 110·5 4. Tighten lock nut (0) once deadhead pressure is set. A-Pressure Compensator Adjusting Screw B-Inlet Pressure Test Port (T2) c-Hlgh Pressure Test Port (T1) D-Lock Nut 1.
Install an adapter to high pressure test port (C). Litho in U.S.A. AllTractorManuals.com