pressure oil (K) to flow into inlet pressure oil (M), flow around the pressure compensator valve (D) and into the crankcase putting the pump into destroke. Shuttle valve (I) is only used to destroke the pump in conjunc- tion with manual destroke or electric destroke solenoid. The first pressure compensator valve position (N) is seen when pump is in FULL STROKE. In this position oil flowing through small orifice in crankcase is equal to the amount of oil flowing into crankcase via the pressure compensator valve (D). As demand for sys- tem oil decreases, system pressure will begin to increase. System pressure increase will move pressure compensator valve (D) toward spring (8). Litho in U.S.A.
115-5 CTM-7 (5-89) 2R3; 115 05 110589 R70;070300 952 050288 3000 Series (HPR)-Operation and Tests The 3000 Series non-unitized designed inlet housing (Q) contains a pressure compensator valve as shown in this cross-section view. The pressure compensator valve (D) working within a fixed sleeve (E) maintains system pressure under varying flow demands. Valve movement is controlled on one end by outlet pressure (K) and on the other by force from spring (8) and crankcase pressure (L). Discharge pressure can be increased or decreased by changing the force on spring (8) using the pressure compensator adjusting screw (A).
The pump may be manually destroked if equipped with an optional manual destroke screw or electric destroke solenoid (H). Shuttle valve (I) moves against spring (J) when manual destroke screw or electric solenoid are engaged. This allows discharge AllTractorManuals.com