H-Input Drive 1-SAE "C" Mount 2--John Deere Mount I-Destroke 1-None 2-Manual 3-Electric (6V)- (Normally Closed) 4-Electrlc (12V)- (Normally Closed) 5-Electric (12V)- (Normally Open) 6-Electric (24V)- (Normally Open) Some pumps will have a part number stamped on the SECOND LINE of the serial number plate instead of the information shown above. Litho in U.S.A.
01-4 CTM-7 (5-E 2AJ, 00 1 0.; 11 1 AWI;R39943 R70; 070300 104& 250489 ...---Serial Number r---Displacement Code r--Revision Code , * ROPV332XXXXXX* 2473R124122* * F-Pressure Setting 1-10000 kPa (100 bar) (1450 psi) 2-16 000 kPa (160 bar) (2300 psi) 3-17 500 kPa (175 bar) (2550 psi) 4-19000 kPa (190 bar) (2750 psi) 5-22 500 kPa (225 bar) (3250 psi) G-Control Type 1-Pressure Compensated 2-Not Currently Used 3-Pressure Compensated- External Control 4-Load Sense 1035 kPa (10 bar) (150 psi) 5-Load Sense 2070 kPa (20 bar) (300 psi) 6-Load Sense 3005 kPa (30 bar) (450 psi) HYDRAULIC PUMP SERIAL NUMBER PLATE-3000 SERIE5-(HPR) I A BCDEFGH .---Produclng Factory r---Pump Variable r--- Series Code General A-Master Machine Code (247) C-Manufacturlng Unit (R) B-Dlsplacement (per rev.) D-Output Drive 1-40 cm3 (2.4 in.3) 1-None 2-52 cm3 (3 In.3) 2-Auxiliary SAE "B" Drive 3-65 cm3 (4 In.3) 3-Through Drive 4-Not Currently Used 4-Auxiliary Gear Pump 5-104 cm3 (6 In.3) 5-Not CUrrently Used 6-115 cm3 (7 In.3) E-Inlet Port 7-130 cm3 (8 In.3) 1-Four Bolt Flange 2-O-Rlng Port The serial number plate on a 3000 Series pump is located on the top-center of the pump.
Pump identity can be determined by the information (configuration code) on the second line of the serial number plate. The information on the serial number plate may be used to identify repair information in the Component Techni- cal Manual. AllTractorManuals.com