C8.3 Industrial Fuel Supply Lines Section A - Adjustment, Repair, and Replacement Page A-9 Remove the banjo capscrew and copper sealing washer at the fuel injection pump inlet. Install CAUTION Do not overtighten the fuel supply line fittings. A fuel leak can occur. Install the fuel line between the fuel lift pump and the fuel filter head. Use two wrenches to tighten the connection on the fuel lift pump. Torque Value: 24 N•m [ 18 ft-lb ] Vent The pressure of the fuel in the line is sufficient to penetrate the skin and cause serious personal injury. Wear gloves and protective clothing. WARNING Vent the high-pressure fuel lines. Loosen the fitting at the injector Number 1.
Place the fuel control in the RUN position. Crank the engine so air can bleed from the fuel lines then tighten the fitting. Torque Value: 30 N•m [ 22 ft-lb ] The pressure of the fuel in the line is sufficient to penetrate the skin and cause serious personal injury. Wear gloves and protective clothing. WARNING Vent each high-pressure line separately until the engine runs smoothly.